A SERVICE OF

logo

65
THERMO – SENSOR
MADE IN CHINA
TM
1
2
3
A
C
B
D
F
E
REMOTE SENSOR
L CLEAR REMOVABLE TABLE STAND
Holds unit in upright position on the flat surface.
MAC/DC 6V ADAPTOR
Activates the Color LCD.
FEATURES
• Remote temperature transmission to the main unit via
433 MHz signal
• Case can be wall mounted using built-in hanger
• 100 feet transmission range without interference
• LCD display of measured temperature
• Temperature display selection in Fahrenheit or Celsius
• Transmission channel selection
BEFORE YOU BEGIN
1. We recommend using alkaline batteries for the main unit
and remote sensor.
2. Avoid using rechargeable batteries.
3. Insert batteries before first use, matching the polarity as
shown in the battery compartment.
4. Always install batteries in the remote sensor before the
main unit.
5. Press RESET after each battery change, using paper clip or
similar tool.
6. During an initial setup, place the main unit as close as
possible to the remote sensor.
7. After reception is established (remote temperature will
appear on the receiver’s display), position the remote sensor
and main unit within the effective transmission range of
100 feet.
NOTE:
1. Avoid setting the time and date on the main unit before the
outdoor temperature is displayed.
2. The effective operating range may be influenced by the
surrounding building materials and how the receiver and
transmitter are positioned.
A LED INDICATOR
Flashes once when the remote sensor transmits a reading to
the main unit.
Flashes twice indicating low battery.
B BATTERY COMPARTMENT
Holds two AA-size batteries.
C RESET
Resets all previous settings.
D CHANNEL SELECTOR
Selects the desired channel before installing batteries.
E WALL-MOUNT RECESSED HOLE
Keeps the remote sensor on the wall.
F °C/ °F SWITCH
Selects the temperature display in Fahrenheit or Celsius.