IU 645 / 9826 8 TowerFeed
TM
for the HP LaserJet 5000
INSTALLATION
Position and Connect Printer
Warning
:
The printer may weigh up to 34 kilograms (50 pounds). Enlist the
help of a second person to lift the unit. To prevent back strain or
injury, bend your knees when lifting the unit.
• Place the TowerFeed unit at the location you wish.
If your TowerFeed is a desktop model, be sure the table or cabinet
is level and sturdy enough to carry the load.
If your TowerFeed is a floor model, be sure to place it on a flat
location.
Floor model TowerFeeds especially must be level!
Note:
If TowerFeed is not level, paper jams and/or left margin deviation
may occur. This is indicated if the left corner of the paper
is 'dog eared' or the left edge of the paper is shredded, or the
left margin is shifted and the print-out skewed.
• Carefully lift the laser printer onto TowerFeed. Place its positioning
holes on the positioning pegs of the TowerFeed top (Fig. 10).
• Connect TowerFeed and printer with the C-Link cable (Fig. 11) -
one end to the printer port (ACCESSORY) and the other end to the
left TowerFeed connector (••). The right TowerFeed connector (•)
allows to connect to further paper handling options.
Note:
Secure the connectors with the screws to ensure proper
connection of the systems.
• Connect the power cables to printer and TowerFeed (Fig. 11).
Note:
When you power on the system, power on FIRST TowerFeed and
then the printer.
Caution:
When rolling TowerFeed and printer to another place, watch out
when crossing doorsteps to not have the unit tipping over or
TowerFeed drawers sliding open.
Fig. 10 Positioning the HP LaserJet 5000
Fig. 11 Connecting the Cables and
Location of the Power Switch
