new. Please discard used batteries in an environmentally
correct way.
9
Battery check ░7░
Set the shooting mode selector to S, C or ). The
camLCD will indicate the battery status by the following
icons:
• The battery capacity is adequate.
• The batteries are low. The camera will function but
replace batteries soon.
• Flashing battery icon. The batteries are exhausted and the
camera will not function.
The battery check icon is always visible when the cam-
era is in active mode. Check battery status regularly.
Power ░8, 9, 10, 11░
ON
Set the shooting mode selector to S, C or ).
S - single exposure mode
C - continuous exposure mode
- self-timer mode
Without film in the camera, the camLCD will display
an ISO symbol, the manually set ISO rating (or '100' in
the case of an automatic DX setting), other camera set
tings and a battery icon, see fig. 9 for example. When
loaded with film, however, the expLCD will also display
a figure that shows the number of unexposed frames
left on the film (fig. 10).
When the shutter release button is pressed halfway
down, the ISO symbol disappears and a TV symbol ap-
pears (time value) together with the selected shutter
speed (fig.ll). After ten seconds of no response, the
ISO symbol appears again, replacing the TV symbol. The
viewLCD display will show selected shutter speed and
exposure information.
OFF
1. Set the shooting mode selector to OFF
2. All indications on all three LCD's disappear.
POWER SAVE
Not For Resale
Free Download at http://www.joe
chan.com/manual
After three minutes of no response from the camera
controls, all indications on the LCDs will disappear and
the camera switches over to stand-by status au-
tomatically.
The camera will reactivate when:
• the shooting mode selector is moved from OFF to S,
C or
.
• the shutter release button is pressed halfway down
