E-9
EnglishDeutschEspañolFrançaisItalianoPortuguês
ġུġࢊ
Póññêèé
Ё᭛
INSTALLATION
Remove the cushioning material for lens protection.
Be sure to remove the cushioning material. If operating focus, zoom, and shift
of the lens with the cushioning material attached, this may cause damage to
the lens.
To prevent increase of temperatures inside the projector, provide a space for draft surrounding the projector. For better heat release, also
provide a space of a minimum distance surrounding the projector, as shown in the figure below.
When installing the projector, be sure to use suspended unit (option) from the ceiling. Call for installation to the local dealer.
See the appropriate instruction manual for more information on the installation hardware you select.
To prevent an accident and ensure safety in the event of an earthquake, fix the display securely into position as described below.
To ensure proper heat radiation, provide at least as much space around the display as shown below.
* Be sure to install the projector at a place that can keep the ambient temperature ranging from 5 to 35 ͠ .
* Run the power cords and connection cables along the wall and at the corners of the floor.
* Connect the projector and the AV selector with optical DVI-D cable with care not to bend the cable sharply. Otherwise the cable may
cause damage.
* To prevent the accident and ensure safety against an earthquake, make measures for prevention of falling.
Projector Section
AV Selector section
TAKING OUT THE PROJECTOR FROM THE CARTON
INSTALLATION
Front Side
Front Side
Cushioning material
Upper
Right
20
20 20
Lower
Left
cm
Rear
cm
20
20
Upper
Lower
Upper
Right
10
10
10
Lower
Left
cm
Rear
cm
10
10
Upper
Lower
