MKP 2000 Remote Control Panel • SIS Operation
MKP 2000 Remote Control Panel • SIS Operation
SIS Operation, cont’d
Command/response table for MKP SIS commands (continued)
Command ASCII Command Response Additional description
(host to MKP) (MKP to host)
Command/response table for MKP SIS commands (continued)
Command ASCII Command Response Additional description
(host to MKP) (MKP to host)
4-114-10
IP setup (continued)
Set Daylight Savings Time
Esc
,
X16
CX Ipx
X16
Set the switcher to display the local time as
Daylight Savings Time (+1 hour) in summer
months.
Read Daylight Savings Time
Esc
CX
X16
Set DHCP on or off
Esc
X1
DH Idh
X1
Read DHCP status
Esc
DH
X1
Set MKP IP address
Esc X17
CI Ipi
X17
Read MKP IP address
Esc
CI
X17
Read hardware (MAC) address
Esc
CH
X18
Set subnet mask
Esc X17
CS Ips
X17
Read subnet mask
Esc
CS
X17
Set gateway IP address
Esc X17
CG Ipg
X17
Read gateway IP address
Esc
CG
X17
Set target (switcher) IP parameters
Esc X17
— or —
X19
SI
Sip
X17
,
X18
,
X19
The set target IP parameters command can be issued with either the
X17
or the
X19
variable, but not both. The response is as shown
regardless of which variable is entered.
Read target (switcher) IP parameters
Esc
SI
X17
,
X18
,
X19
Set administrator password
Esc X20
CA Ipa
X20
Clear administrator password
Esc
•CA Ipa•
IP setup (continued)
Read administrator password
Esc
CA
X20
Set user password
Esc X20
CU Ipu
X20
When you have connected multiple MKPs to control a switcher through a primary MKP control panel, do not set a user password on the
primary MKP.
Clear user password
Esc
•CU Ipu•
Read user password
Esc
CU
X20
Switch web page priority
Esc X21
Cpag Iwp
X21
Read web page priority
Esc
Cpag
X21
Set verbose mode
Esc
X1
CV Vrb
X1
Set MKP to report changes from other sources.
Read verbose mode
Esc
CV
X1
Read the verbose mode.
Read connection’s security level
Esc
CK
X10
