Setting Up Your System for Network Printing 17
Configuring the Network Interface
Configure the network interface for use on a TCP/IP network.
1. Make sure that the printer is turned on, and the LCD displays READY.
2. Press the Menu r button on the printer to enter the printer’s menu system.
3. Press d to highlight NETWORK SETUP, then press r.
4. Press r, then d to highlight ENABLE.
5. Press OK. A checkmark appears next to ENABLE to show that it’s selected.
6. Press r, then d to highlight IP ADDRESS SETTING.
7. Press r, then press u or d to choose one of the following IP configuration
settings:
❏ Choose AUTO if your network uses a DHCP server to configure your
network devices’ IP settings automatically.
❏ Choose PANEL if you would like to configure the printer’s IP settings
manually.
8. Press OK. A checkbox appears next to the setting you selected.
9. Press l, to go back, then do one of the following:
❏ If you selected AUTO as the IP address setting, press the Pause
button to exit the printer menu. Then continue with step 14.
❏ If you selected PANEL as the IP address setting, continue with step 10.
10.Press d to highlight IP, SM, DG SETTING, then press r. The LCD displays
the IP address.
11.Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r. The
LCD displays the subnet mask.
12.Press u
or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r. The
LCD displays the default gateway.
