Figure 23
Installation of Fan Assembly onto
Hanger Bracket
(Close-to-the-Ceiling)
1. Partially install two #10-24x3/16 pan head screws
and lock washers (supplied) into the hanger
bracket as shown (Figure 24). Observe the ceiling
cover to determine exact installation location of
both screws. The protruding screws will be used to
engage the ceiling cover.
2. Lift the fan assembly up to the hanger bracket.
Engage the slots in the ceiling cover with the
loosened screws in the bracket and turn the cover
counterclockwise (Figure 24). Be sure that the
lockwashers are between the screw heads and the
ceiling cover. Immediately tighten both screws to
lock the fan onto the hanger bracket.
3. Install the two #10-24x3/16 screws and
lockwashers (supplied) into the hanger bracket ;
tighten all screws securely.
Figure 24
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box
and not pinched between the ceiling cover and the
ceiling.
WARNING
!
