EPD133BL EPD133BL
98
1
2
CR2025 CR2025
Please put the battery into the remote control as shown below.
When using remote control,make sure the infrared window is pointed to infrared receiving
window of the machine.The distance between machine and remote control must be within
3 metres.Please refer to the following illustration.
The Use of Remote Control
0
30
0
30
Note:
1. To avoid malfunction, DO NOT place the device near a damp environment.
2. Do not expose the infrared receiving window to direct sunlight.
3. Replace with a new battery if the remote control isn't working properly.
Basic Operation
DVD
MPEG4
SVCD
VCD CD
MP3
Play/pause
Cursor button
ENTER
Title Menu
SETUPSETUP
MENUMENU
MUTEMUTE
EPD133BL
Playing disc of DVD, MPEG4, SVCD, VCD, CD, MP3.
2. Open the disc door and insert a disc into the door with the label side facing up.
3. Close the disc door.The unit will load the disc and start playing.
4. Press“ ”once to stop playback; press“ ”to resume playback from the point
where you stopped;press“ ”twice to stop playback completely.
5. During playback,press“ ”to pause; press it again to resume playback.
6. When the playing is finished, please turn off the power by sliding ON/OFF switch to OFF.
7. For some DVD disc with Title or Chapter menu, press“MENU”button to enter menu
page, and use“ ”to select. Press ENTER to confirm.
1. After connecting power to the unit, turn on the unit by sliding the ON/OFF switch to ON,
the source menu will be displayed on the screen:
Press " " to enter DVD mode or Media mode and press OK button to confirm.
When selecting "MODE", ensure to insert USB or SD/MMC card properly.
Note:
Please do not disconnect USB devices or remove SD/MMC cards while they are in use.
Functional failure may occur if removed incorrectly.
