Cut along dotted line and fold where indicated for a quick and easy reference to keep in your purse or wallet.
QUICK REFERENCE OPERATING CARD:
To arm using your remote
▼ You can activate, or arm, the system by pressing Button I of your
transmitter for one second. When the system arms, you will hear a
short siren sound, or chirp, and see the parking lights flash once. If
the vehicle’s power door locks have been connected to the system,
the doors will lock.
To disarm using your remote
▼ To disarm the system, press Button I again.You will hear two chirps,
and the parking lights will flash twice. If power locks are connected
to the system, the doors will unlock. If the siren chirps either four or
five times when disarming, see Diagnostics section. This is called
Tamper Alert.
Arming While Driving
▼ Press Button I on your transmitter while the vehicle is running. The
system will chirp once and then once more to indicate that the igni-
tion is on.
Disarming Without a Transmitter
▼ Turn on the ignition. Push the Valet
®
switch within 15 seconds. The
system should now disarm. If it does not, you may have waited too
long, so turn the ignition off and on and try again.
To enter or exit Valet
®
Mode
▼ Turn ignition to “run” position, then turn to “off” position. Press and
release the Valet
®
switch within 10 seconds. The Status LED will
light solid if you are entering Valet
®
Mode, and it will go out if you are
exiting Valet
®
Mode.
To activate panic mode
▼ Hold Button I down for 1.5 seconds.
To exit panic mode
▼ Press Button II on the transmitter.
To activate Silent Mode
™
▼ Press Button II briefly before arming or disarming, and the confirma-
tion chirp(s) will be eliminated for that one operation only.
✂
