4 February 2005 Dodge Transmission Instructions
5
18. Connect the electrical wires to the park/neutral position switch and transmission
solenoid(s). Be sure the transmission harnesses are properly routed.
CAUTION: It is essential that correct length bolts be used to attach the converter to the
drive plate. Bolts that are too long will damage the clutch surface inside the converter.
19. Install the torque converter to drive plate bolts using Loctite. On models with a 12.2”
converter, tighten bolts to 47 Nm (35 ft. lbs.).
20. Install the torque converter housing access covers.
21. Install the cooler line bracket.
22. Connect the cooler lines to the transmission.
23. Install the transmission fill tube. Install a new seal on the tube before installation.
24. Align and connect the drive shaft.
25. Adjust the gearshift linkage and throttle valve cable if necessary.
26. Lower the vehicle.
27. Reconnect the negative ground cable(s) to your battery(s).
28. Fill the transmission with ATF+4, Type 7176 fluid.
BD Engine Brake Inc.
Plant Address: #A10 – 33733 King Road, Abbotsford, BC, Canada V2S 7M9
US Shipping: #88 – 446 Harrison St., Sumas, WA, USA 98295 | US Mailing Address: P.O. Box 231, Sumas, WA, USA, 98295
Phone#: (604) 853-6096 | Fax: (604) 853-8749 | Web: www.dieselperformance.com
