www.desatech.com
119162-01B18
INSTALLATION
Continued
CAUTION: After installa-
With heater set to Hi, check to
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place rear log on base assembly as shown in
Figure 23. The log will t over right end of
burner and rest in the middle of U-burner.
2.
Place middle log in front of U-burner and against
the edges of plate as shown in Figure 24.
3. Place front left log (#3) onto pan burner be-
tween log #2 and grate. Back of log #3 should
t against front of log #2. Place front right
log (#4) onto pan burner between log #2 and
grate. Logs #3 and #4 have notched ends to
t over end of pan burner as shown in Figure
25. Back of log #4 should t against front
of log #2.
4. Place log #5 as shown in Figure 26. Top will
t onto right pin on back log (#1). Front of log
will t onto right pin on log #2.
5. Place left crossover log (#6) over left pins
on logs #1 and #2 as shown in Figure 26.
Figure 24 - Installing Log #2
Figure 25 - Installing Logs #3 and #4
Figure 26 - Installing Logs #5 and #6
Figure 23 - Installing Log #1
