TO REPLACE FUSE (See Fig. 27)
Replace with 30 amp automotive-type plug-in fuse, The
fuse holder is iocated in the engine compartment, directly
in front of the dash_
SERVICE AND ADJUSTMENTS
TO REMOVE HOOD AND GRILL (See Fig. 28)
..................... llUln u illll, ii i
I _ CAUTION: Muffler Is hot. Be careful
|
I _ when removing retainer springs from
!
I ,oo pivo,brackets
FUSE
G' HOLDER
FIG. 27
TO REPLACE HEADLIGHT BULB
• Raise hood,'
• Pull bulb holder out of the hole in the backside of the
grill.
. Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting
• Check wiring Seethe e{ectrica] wiring diagram inthe
Repair Parts section of this manual
i,
• Raise hood.
. Unsnap headlight wire connector.
• Remove retainer springs from hood pivot brackets.
• Stand in front of tractor. Grasp hood at sides, tilt
forward and lift off of tractor
• To reinstall, slide hood pivot brackets into slots in
frame. Repiace retainer springs.
° Reconnect headlight wire connector and c_ose hood_
HEADLIGHT
WiRE
CONNECTOR
HOOD
REMOVE
RETAIN ER
SPRINGS
FIG, 28
22
