STEP16: (SEEFIGURE16)
, Assembleballendofcontrolcableupthroughholein
cableendfittingandpulluntilballslipsinsidecurled
edgeoffitting.Ifballwon'tslipunderedgeofcurl,it
willneedtobeinsertedthroughopenendofcurl.
Assemble1/4"x 1ol/2"(B)hexboltdownthroughthe
cableendfitting,the5/8"longspacer(T)andtheleft
handholeinthechannelassembly.Securewitha
1/4"nylocknut(J).Tighten.
NOTE:Makesurethecablemountbracketisaligned
withthecableendfittingtopreventbindingofcable.The
otherendofthecontrolcablewiltbeattachedina later
step.
CABLE END 1/4" x 1o1/2"
HTTmNG HEX BOLT (B)
5/8" SPACER (T)
ASSEMBLY
t
I
I
1/4" NYLOCK/z
NUT (J)
HOLE
REAR --,--_-
FIGURE 16
(Left Hand Side View)
STEP 17: (SEE FIGURE 17)
, To attach the blade to the channel assembly, align
the notched holes in the pivot plate with the notched
holes in the blade, insert a 1/8" x 1ol/4" cotter pin (P)
down through the hole at the bend in the blade pivot
shaft. Spread the ends of the pin. From the left side
insert the blade pivot shaft, bend facing top of blade,
through the notched holes. Secure the shaft with
another 1/8" x 1ol/4" cotter pin (P) through the end
hole in the shaft. Spread the ends of the pin.
Remove the plastic cap and one 3/8" hex nut from the
bolt in the blade adjust spring. Adjust the remaining
3/8" hex nut down approximately 1" onto the bolt
threads. Hook the spring over the spring mount rod.
Place the bolt up through the hole in the top edge of
the blade and reassemble the other 3/8" hex nut to
the bolt and tighten down against the top edge of the
blade. Replace the plastic cap over the end of the bolt
threads.
1/8"x 1ol/4"
PmVOT
SHAFT
3/8" HEX NUT
\
\ (BOTTOM)
X
BLADE
SPRING
MOUNT
ROD
BLADE
ADJUST
\ SPRING
PUVOTPLATE
1/8" x 1-1/4"
COTTER PUN(P)
NOTCHED HOLE
FIGURE 17
(Right Hand Side View)
STEP 18: (SEE FIGURE 18)
, Assemble the large 1/2" washer (Q) onto the channel
pivot pin.
Attach the channel assembly to the tractor by placing
the end of the channel assembly up inside the pivot
support bracket on the tractor. Align the hole in the
pivot support bracket with the second hole from the
end in the channel assembly. Insert the channel pivot
pin through the aligned holes from the left side and
secure with a hairpin cotter (O).
PmVOTSUPPORT
BRACKET
1/2" WASHER (Q)
CHANNEL
PmVOTPUN
HAmRPmN
COTTER (O)
CHANNEL
ASSEMBLY
FIGURE 18 (Right Hand Side View)
9
