Cisco Systems SG100D08PNA Manual

next previous

Cisco SG100D-08 Unmanaged Gigabit Switch Quick Start Guide 6

STEP 3 Insert a screw into each hole, leaving a gap between the surface

and the base of the screw head of at least 0.1 inches (3 mm).

STEP 4 Place the unmanaged switch wall-mount slots over the screws and

slide the unmanaged switch down until the screws fit snugly into

the wall-mount slots.

STEP 5 Connect the unmanaged switch to the other devices, as described

in the “Connecting the Equipment” section.

Flat Surface Installation

To deploy the device on a desktop or other flat surface:

STEP 1 Place the unmanaged switch on a desktop near an AC power

source.

STEP 2 Connect the unmanaged switch to the other devices, as described

in the “Connecting the Equipment” section.