Contents
ii
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
OL-8787-04
InfiniBand General Services Managers and Agents 6
SNMP Support 7
SNMP MIBs 7
CHAPTER
2 Installation 9
Statement 1019—Main Disconnecting Device 10
Statement 1045—Short-circuit Protection 11
Statement 1074—Comply with Local and National Electrical Codes 13
Statement 1075—Hazardous Voltage or Energy Present on DC Power Terminals 14
Planning the Installation 15
Environmental Requirements 15
Rack Specifications and Recommendations 16
Installing and Routing Cable 16
Power Requirements 17
Installation Tasks Checklist 18
Safety Information 18
Tools and Equipment Required 20
Check the Installation Site 21
Unpack the Equipment 21
Installation Tasks 22
Mounting Kit 22
Mark the Rack 22
Install the Rails in the Rack 22
Rack-Mount the Switch 24
Installing the Switch Face Plate 25
Removing a Module or Blank 26
Installing the Spine and Leaf Modules 26
Connect Equipment to the Ports and Power On the System 27
Bringing Up the System For the First Time 29
Changing the SFS 7012 IP Address and Default Gateway via the CLI 30
Updating Management Spine IP Addresses in a Redundant Management Configuration 31
SFS 7012 Component LEDs 34
SFS 7012 Leaf and Spine Module LEDs 35
Accessing On-line Help 37
Shutdown Procedures 38
Rebooting Components from Chassis Viewer 38
