2-39
Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04
Chapter 2 Switch Installation
Connecting Destination Ports
To attach the alarm connector to the front panel of the switch, follow these steps:
Step 1 Insert the alarm connector into the receptacle on the switch front panel. See Figure 2-25.
Figure 2-25 Connecting the Alarm Connector to the Switch
Step 2
Use a ratcheting torque flathead screwdriver to tighten the captive screws on the sides of the alarm
connector.
Connecting Destination Ports
These section provide more information about connecting to the destination ports:
• Connecting to 10/100 and 10/100/1000 Ports, page 2-40
• Installing and Removing SFP Modules, page 2-42
• Connecting to SFP Modules, page 2-44
• Connecting to a Dual-Purpose Port, page 2-46
1 Alarm connector upper captive screw
16TC
±12/24/48
0.5-3.0A
331215
1
