Configuring Token Ring Inter-Switch Link
TRISL Configuration Examples
BC-160
Cisco IOS Bridging and IBM Networking Configuration Guide
78-11737-02
IPX Routing Source-Routed Frames Between a TRISL VLAN and a Token Ring
Interface Example
Figure 60 shows IPX routing source-routed frames between a TRISL VLAN and a Token Ring interface.
Figure 60 IPX Routing Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface
The following is the configuration for the router:
ipx routing
!
interface TokenRing 3/1
ipx network 1
multiring all
!
interface fastethernet4/0.1
ipx network 10
encapsulation tr-isl trbrf 999 bridge-num 14
multiring trcrf-vlan 200 ring 100
multiring all
The following is the configuration for the Catalyst 5000 switch with the Token Ring switch module in
slot 5. In this configuration, the Token Ring port attached to ring 1 is assigned to the TrCRF VLAN 40.
#vtp
set vtp domain trisl
set vtp mode server
set vtp v2 enable
#drip
set tokenring reduction enable
set tokenring distrib-crf disable
#vlans
set vlan 999 name trbrf type trbrf bridge 0xe stp ibm
set vlan 200 name trcrf200 type trcrf parent 999 ring 0x64 mode srb
set vlan 40 name trcrf40 type trcrf parent 999 ring 0x1 mode srb
#add token port to trcrf 40
set vlan 40 5/1
set trunk 1/2 on
5500
51886
Fast Ethernet 4/0.1
etwork 1
Network 10
Catalyst 5000 switch
Token Rin
switch
module
TrCRF VLAN 4
Slot 5
Port 1
TrBRF 999/Bridge 14
End station
Token
Ring 1
End station
End station
Token
Ring 2
