2-315
Catalyst 6500 Series Switch Command Reference—Release 7.6
78-15328-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
set l2protocol-tunnel trunk
set l2protocol-tunnel trunk
To set Layer 2 protocol tunneling on trunks, use the set l2protocol-tunnel trunk command.
set l2protocol-tunnel trunk {enable | disable}
Syntax Description
Defaults Layer 2 protocol tunneling on trunks is disabled.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines Do not enable or disable Layer 2 protocol tunneling on trunks when active layer 2 protocol tunnels are
already configured. If you plan to configure Layer 2 protocol tunneling on trunks, do so before
performing any other Layer 2 protocol tunneling tasks.
Examples This example shows how to enable Layer 2 protocol tunneling on trunks:
Console> (enable) set l2protocol-tunnel trunk enable
Warning!! Clear any layer 2 protocol tunnel configuration on trunks
before using this command.
Layer 2 Protocol Tunnel on trunks is allowed.
Console> (enable)
This example shows how to disable Layer 2 protocol tunneling on trunks:
Console> (enable) set l2protocol-tunnel trunk disable
Warning!! Clear any layer 2 protocol tunnel configuration on trunks
before using this command.
Layer 2 Protocol Tunnel on trunks is not allowed.
Console> (enable)
Related Commands show l2protocol-tunnel statistics
show port l2protocol-tunnel
enable Enables Layer 2 protocol tunneling on trunks.
disable Disables Layer 2 protocol tunneling on trunks.
