Chapter 1: Introduction
9
Safety Considerations
For safe and efficient operations, you should always install the components as shown in
Supported Rack Configurations:
• Configuration for One RAID System (AAMK36A) on page 6.
• Configuration for Two RAID Systems (AAMK36A2) on page 7.
• Configuration for Three RAID Systems (AAMK36A3) on page 7.
• Configuration for Four RAID Systems (AAMK36A4) on page 8.
CAUTION To guarantee air flow for cooling the system, filler panels must be installed as
shown in the configurations.
WARNING The disk enclosures, controller enclosures, and CRUs are heavy. Allow for
two people to lift and move each of these components.
WARNING To avoid a top-heavy rack, never put a disk enclosure into the top rack slot. A
controller enclosure, which weighs less than a disk enclosure, must always be in the top
slot.
WARNING Never slide more than one rack component forward at the same time. This
can cause the entire rack to become unstable.
Note Remember that there must be a disk enclosure located immediately beneath the
controller for cabling.
