SKU 99887 For technical questions, please call 1-800-444-3353. Page 6
5.
FIGURE D
JACK
BRACKET
(3)
NUT
(14)
SHAFT
(22)
LOWER
LINKAGE
(5)
Attach the Jack (1) to the Jack
Bracket (3) and Post (19) using two
Hex Bolts (2), two Nuts (4), one Shaft
(21), and one Clip Ring (20).
(See Figure E.)
6.
FIGURE E
CLIP
RING
(20)
JACK
(1)
HEX
BOLT
(2)
NUT
(4)
JACK
BRACKET
(3)
POST
(19)
SHAFT
(21)
For storage purposes, insert the
Handle (18) and Position Pin (17) into
the top of the Post (19).
(See Figure F.)
7.
FIGURE F
HANDLE
(18)
POSITION PIN
(17)
POST
(19)
IMPORTANT: After all assembly pro-
cedures are performed the hydraulic
system of the Motorcycle Lift MUST
be bled and î‚¿lled with hydraulic oil
(not included). To do so:
a. Remove the Oil Filler Plug.
(See Figure G.)
b. With the Oil Plug (38A) removed, use
one foot to step on and keep the Arm
Lift (13) assembly down, while you
quickly pump the Handle (18) ten
times. This will bring all of the air out
of the system.
c. Continue pumping until no more air
bubbles appear in the Oil Filler Re-
ceptacle.
d. Fill to the top of the Oil Filler Recep-
tacle with hydraulic oil.
e. Replace the Oil Plug (38A).
HANDLE
POSITION PIN
POST
FIGURE F
