132 External Connections
3 Touch on the individual photos you want to copy.
• A checkmark O will appear on photos selected. Touch a selected
photo again to remove the checkmark.
• To select all the photos at once: Touch [Select All] instead of touching
individual photos. (Remove in advance any checkmarks from photos
you may have selected individually.)
4 Copy the photos.
* Touch [Stop] to interrupt the operation while it is in progress.
IMPORTANT
• Observe the following precautions while the ACCESS indicator is on or
flashing. Failing to do so may result in permanent data loss.
- Do not open the double memory card slot cover.
- Do not disconnect the power source or turn off the camcorder.
- Do not change the camcorder’s operating mode.
• When copying photos onto an Eye-Fi card in memory card slot Y, pho-
tos will be uploaded automatically if you are within the range of a config-
ured network. Always verify that Eye-Fi cards have been approved in
the country/region of use. See also Using an Eye-Fi card (0 150).
NOTES
• In the following cases, you will not be able to copy recordings to the
memory card:
- If the double memory card slot is open.
- If the LOCK switch on memory card Y is set to prevent writing.
- If there is no memory card in memory card slot Y.
• Scenes that were edited using the supplied software ImageMixer 3 SE
and were then written back to the camcorder cannot be copied to the
memory card.
• If there is not enough space on memory card Y, as many photos as
possible will be copied before stopping the operation.
[Edit] 8 [Copy (f97)] (c only) or [Copy
(497)] 8 [Yes]* 8 [OK]
