89
Editing
E
Dubbing
1. Set the camcorder to PLAY (VCR) mode and load a recorded cassette.
Use a tape recorded in SP, 12-bit mode with this camcorder.
2. Open the menu and select [AUDIO SETUP]. Select [AUDIO DUB.], set it
to [AUDIO IN] or [MIC. IN] and close the menu.
3. Locate the scene you wish to start audio dubbing.
4. Press the PAUSE a button on the wireless controller.
5. Press the AUDIO DUB. button on the wireless
controller.
“AUDIO DUB.” and “ a” appear.
6. Press the PAUSE a button on the wireless controller
to begin dubbing.
• Audio device: Begin playback.
• Microphone: Speak into the microphone.
7. Press the STOP 3 button on the wireless controller
to stop dubbing.
Audio device: Stop playback.
❍ Use only tapes recorded in SP mode 12-bit audio sound with this camcorder.
Audio dubbing will stop if the tape has a blank section or a section recorded in
LP mode or 16-bit mode.
❍ You cannot use the DV terminal for audio dubbing.
❍ If you add sound to a tape not recorded with this camcorder, sound quality
may decrease.
❍ Sound quality may decrease when you add sound to the same scene for more
than 3 times.
❍ When you connect an audio device, check the picture on the LCD screen and
the sound via built-in speaker or audio device. You can also connect a TV via S-
video terminal.
❍ When you use the built-in microphone, you can either connect a TV via AV
terminal to check the picture, or headphones to check the sound. When you
connect a TV via S-video terminal, you can check the picture on the TV screen
and the sound with headphones connected to the camcorder.
❍ Set the zero set memory at the end of the scene you wish to dub audio. The
camcorder will automatically stop audio dubbing at that point.
