Settings Menu
2-12
2
Printer Settings Menu
■ Margin
-1.20 to +1.20 inch (in increments of 0.01 inch); 0.0
*
inch
This setting sets the page margin in inches. The settings can be set between
-1.20" (-30.0 mm) and +1.20" (+30.0 mm) in increments of 0.01" (0.5 mm).
Use [ ] to increase the width of the inside margin.
Use [ ] to increase the width of the outside margin.
You can specify the edge along which the margin will be created in the Binding
setting (previous setting). To create a margin along one of the edges of the paper,
use this setting in combination with the Binding setting.
IMPORTANT
If this setting moves the image outside the printable area, part of the image may be
cut off.
NOTE
•
If this setting is used in combination with the Offset X/Offset Y setting, the values of
the two settings are added together.
•
Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key is
pressed. Pressing [ ] decreases the value by 0.01" (0.5 mm) each time. Holding
down either [ ] or [ ] continuously speeds up the value alteration.
[ + ]
[ - ]
[0 inch]
Left Margin
Center Center Center
Right Margin
