7F06-02 FDDI SmartSwitch Interface Module User’s Guide 1-1
CHAPTER 1
INTRODUCTION
Welcome to Cabletron Systems
7F06-02 FDDI SmartSwitch Interface
Module User Guide
. This guide is a simple reference for installing and
using the 7F06-02 Module. Before installing this module, you should
carefully read through this manual to gain a full understanding of its
capabilities.
The 7F06-02 Module is a two-port FDDI module. This module connects
to a network and the 7X00 SmartSwitch™ Control Module in the 7C03,
7C04 or 7C04-R MMAC SmartSwitch via a SmartSwitch bus.
1.1 USING THIS MANUAL
Chapter 1,
Introduction
, discusses the capabilities and special features of
Cabletron Systems 7F06-02 Module. This chapter also includes a list of
related manuals.
Chapter 2,
Network Requirements
, contains a list of available FPIMs
and the network requirements that should be considered before installing
the 7F06-02 Module.
Chapter 3,
Installation/Removal
, contains instructions for installing and
removing the 7F06-02 in the 7C03 MMAC SmartSwitch, the 7C04
Workgroup SmartSwitch or the 7C04-R Workgroup SmartSwitch.
Chapter 4,
Troubleshooting
, contains instructions for using LANVIEW
®
(Cabletron Systems built-in diagnostic and status monitoring system).
Chapter 5,
Technical
Specifications
, provides detailed information about
the physical characteristics of the 7F06-02 Module.
1.2 THE 7F06-02 MODULE
The 7F06-02 Module, shown in Figure 1-1, provides two fiber optic ports
via front panel FPIM modules.
