3
#2 twice within 2 seconds your alarm will respond by saying “Thank you” twice indicating it received your
command. When arming with transmitter button #2, simply reverse the procedure. The next time the alarm
is set it will go back to the original setting.
Setting the Current Sensor
Disarm the system. Press and hold transmitter button #4 (panic) until the alarm chirps 2 times (Approximately
5 seconds). This indicates that current sensing is now turned off. To turn Current Sensing back on: Disarm
the system. Press and hold transmitter button #4 (panic) until the alarm chirps 1 time (Approximately 5
seconds). This indicates that current sensing is now turned on.
NOTE: Factory setting is ON.
Automatic Passive Arming
To activate passive arming, press and hold down button #2 (Arm/Chirp) for ten seconds. The alarm will
respond with a tone and then say “system armed”. Your alarm will automatically arm in 60 seconds after
you turn off your engine. After disarming your system, you have approximately 60 seconds to start your
motor before the alarm will rearm itself. To deactivate passive arming, press and hold down button #2
(Arm/Chirp) for ten seconds. The alarm will respond with one tone and say “system disarmed”. Your alarm
now must be armed by using the remote transmitter.
High Theft Area
To make your alarm say “system armed” every 30 seconds, press button #3 (Finder) immediately after arming
your alarm with button #1 (Arm/Voice). To make your alarm chirp twice every 20 seconds, simply press button
#3 (Finder) immediately after arming your alarm with button #2 (Arm/Chirp). Either option will be for
this arming only. The system will return to normal operation after it is disarmed. NOTE: If the vehicle
is violated, a man’s voice shouts, “I was tampered with!” The siren sounds. After 30 seconds, if the
violation stops, the alarm will stop and rearm itself.
