. .
25
LCD REMOTE CONTROL TRANSCEIVER
EXIT: Press and hold the SET button for 2 seconds or leave it for 10
seconds, the system will exit the programming mode.
1. Timer Setting: Example to AM10:30
1. Press and hold the SET button for 3 seconds, with two-melody sound
and the Hours digit flashes for adjusting.
2. Press the
or
button to decrease or increase the Hour digit
until AM10:xx.
3. Press the SET button once again then the Minute digit flashes for
adjusting.
4. Press the
or
button to decrease or increase the Minutes digit
until AM 10:30.
5. Press the SET button for 2 seconds with one-melody sound to confirm
exiting the timer program mode.
2. Alert Alarm Timer Setting: Example to PM 6:30
1. Press and hold the SET button for 3 seconds, with two-melody sound
and the Hours digit flashes for adjusting.
2. Press the SET button twice, the LCD screen will shows
icon and
Hours digit is flashes for adjusting.
3. Press the
or buttons to decrease or increase the Hour digit
until PM 6:xx.
4. Press the SET button once again then the Minutes digit flashes
for adjusting.
5. Press the or button to decrease or increase the Minutes digit
until PM 6:30.
6. Press the SET button once again then
icon flashes for alert alarm
ON/ OFF setting
7. Press the
button to start the Alert Alarm Timer, and the ON
icon will show on the LCD screen. Press the button to stop the
Alert Alarm Timer, and the OFF icon will show on the LCD
screen.
8. Press SET button for 2 seconds with one-melody sound to confirm
exit the timer program mode.
