35
N Wireless Modem Router
SECTIONSTable of Contents 1 2 3 4 6 7 8 9
10
5
ALTERNATE SETUP METHOD
1. WAN IP Address – Enter an IP address assigned by your ISP for the
Router WAN interface.
2. Subnet Mask – Enter a subnet mask assigned by your ISP.
3. Use Static Default Gateway – Enter a default gateway IP address.
If the Router cannot find the destination address within its local
network, it will forward the packets to the default gateway assigned
by your ISP.
4. VPI/VCI – Enter your Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI) parameter here. These identifiers are assigned by
your ISP.
5. Encapsulation – Select LLC or VC MUX your ISP uses.
Click “Apply Changes” to save and activate your settings. To go back
to the original settings before saving, click “Clear Changes”. Or click
any of the Quick-Navigation links for other options. Your new settings
will not be saved unless your click “Apply Changes”.
Setting your ISP Connection Type to Static IP (IPoA)
This connection type is also called “Classical IP over ATM” or “CLIP”, which your ISP provides a fixed IP for your Router to connect to the Internet.
