A SERVICE OF

logo

Open as PDF
next previous
40
G Wireless Modem Router
SECTIONSTable of Contents 1 2 3 4 6 7 8 9 105
MANUALLY CONFIGURING YOUR ROUTER
6. You will see the Router’s user interface in the browser window.
Click “Wireless Bridge” (2) on the left-hand side of the screen. You
will see the following screen.
7. Check the box that says, “Enable ONLY specific Access Points
to connect” (1).
8. In the field named “AP1” (3), type in the MAC address of your
secondary access point. When you have typed in the address,
click “Apply Changes”.
9. Bridging is now set up.
Note: It may take up to a minute for the bridged connection to properly
establish itself. In some cases, it may be necessary to restart the access
point and the Router to initiate the bridge.
(1)
(3)
(2)