4948
Alternate Setup Method
4948
Alternate Setup Method
Setting your Connection Type if you are a Telstra
®
BigPond Cable User
[Australia Only] Your user name and password are provided to you by
Telstra BigPond. Enter this information below.
Note: Your user name should be the same as your email address,
but with the “@bigpond.com” part removed.
Your password
should be the same as the password you use
for your BigPond email account.
Choosing your state from the drop-down menu (1) will automatically
fill in your login server IP address. If your login server address is
different than one provided here, you may manually enter the login
server IP address by placing a check in the box next to “User decide
login server manually” (4) and type in the address next to “Login
Server” (5). When you have entered all of your information, click
“Apply Changes” (7). After you apply the changes, the Internet Status
indicator will read “connection OK” if your Router is set up properly.
Note: You may have to turn your modem off for 20-40 minutes to allow
any active BigPond connections to disconnect from BigPond servers.
(1)
(2)
(3)
(4)
(5)
(7)
