While the power save mode, the LCD remote transceiver “sleep” until a button is pushed,
extends the life of battery. When power save mode is “Off”, the remote control will wake up
periodically to check for messages from the security module.
1. Press and hold all four remote control buttons simultaneously unit one long
beep is heard. Programming has now been entered.
2. Within 5 seconds, press the button to toggle “On” or “Off”. The remote will
beep once for “On”, twice for “Off”. When power save mode is “On”, the
icon on the LCD screens to indicate entry the “power save mode”
3. To exit programming mode, take no action for five seconds. The remote control
will generate two long beeps to indicate programming mode has been exited.
Screen Lamp ON:
Press the button once; the LCD screen lamp will turns on for 5 seconds
When you want to check the system’s present status
through the LCD screen, Press the transceiver button first, within 3 seconds
press and buttons at the same time. It responds with one melody sound, the
LCD screen should be illuminated.
Note: If it has no responds then you are out of range.
Clear the Flash Icon and Melody Sound:
Cycle ignition then press the button first, within 3 seconds press and buttons at the
same time. It will clear the flash icon and melody sound on the LCD screen transceiver
Stop The Trigger Melody Sound:
While triggering the alarm the LCD screen will alert user through melody sound and flashing
trigger icon, press any button on the LCD remote transmitter to stop melody sound only, the
remote control buttons will not send a command to the system.
