2
Figure 1 - Atd-5800 and Atd-5810 Nomenclature
pump handle
release valve
ram plunger
oil ller
screw
dust cover
hose
hose coupler
ram
coupler
SPECIFICATIONS
Save these instructions. For your safety, read and understand the information contained within. The owner and
operator shall have an understanding of this product and safe operating procedures before attempting to use this
product. Instructions and Safety information shall be conveyed in the operators native language before use of this
product is authorized. Make certain that the operator thoroughly understands the inherent dangers associated with
the use and misuse of the product. If any doubt exists as to the safe and proper use of this product as outlined in this
factory authorized manual, remove from service. Inspect before each use. Do not use if broken, bent, cracked or
otherwise damaged parts are noted. If any component of this product has been or suspected to have been subjected
to a shock load (a load dropped suddenly, unexpectedly upon it), discontinue use until checked out by an Atd Tools
authorized service center. Owners and operators of this equipment shall be aware that the use and subsequent
repair of this equipment may require special training and knowledge. It is recommended that an annual inspection
be done by qualied personnel and that any missing or damaged parts, decals, warning / safety labels or signs be
replaced with factory authorized replacement parts only. Any component of this Body Repair Kit that appears to be
damaged in any way, is worn or operates abnormally shall be removed from service immediately until such time as
it can be repaired/replaced. Labels and Operator's Manuals are available from the manufacturer (see Replacement
Parts, pages 7 & 8).
PRODUCT DESCRIPTION
Atd Tools Hydraulic Body Repair Kits are designed to be used for pushing, spreading, and pressing of vehicle body
panels as well as various component parts and assemblies. A variety of attachments are included.
WARNING: when extension tubes and/or offset attachments are used, the rated capacity is always reduced
by 50 % for each tube or offset attachment connected. See Parts Section on page 7 & 8 for identication of
"offset" attachments.
Model
Pump
Capacity
Ram
Capacity
Ram
Number of
Attachments
Closed Height Extended Height
Atd-5800 8,000 psi 4 Ton 10-3/4” 15-5/8” 14
Atd-5810 10,000 psi 10 Ton 13-3/4” 19-3/4” 13
1. Before using this product, read the owner's manual
completely and familiarize yourself thoroughly with
the product, its components and recognize the
hazards associated with its use.
2. Inspect before each use. Do not use if bent, broken,
leaking or damaged components are noted.
3. Check to ensure that all parts of your kit are included
(see illustration and parts list).
4. Carefully remove the dust caps and plugs from hose
coupler and ram coupler.
5. Connect hose coupler to ram coupler, ensure that
there are no uid leaks.
6. Locate and open release valve. Close release
valve clockwise and pump handle until ram is fully
extended, then open release valve counter-clockwise
until ram has fully retracted.
7. With ram fully retracted and release valve open, place
pump in horizontal position. Locate and open oil ller
screw (on reservoir body, near the back). This will
release air trapped within the reservoir. Retighten
the oil ller screw.
8. If using with air actuated units, an air source of at
least 7.8 CFM @ 90 PSI is required.
BEFORE USE
