A SERVICE OF

logo

Open as PDF
next previous
4
Secure the ends of the hitch tubes together using two 7.
5/16 x 2-1/2" hex bolts (8) and 5/16" nylock nuts (14).
Do not tighten yet.Seegure3.
FIGURE 2
FIGURE 3
Attach the hitch tubes (5) to the third hole from the 6.
front of the tray assembly using two 5/16 x 1" hex
bolts (11) and 5/16" nylock nuts (14). Do not tighten
yet.Seegure2.
8
8
14
11
11
14
14
5
5
ASSEMBLY INSTRUCTIONS
ASSEMBLY OF SMARTLINK PLATFORM
Rotate the end plates attached to the tray assembly 1.
downtoaverticalpositionasshowningure1.
Remove the bolt and nylock nut from the front right 2.
cornerofthetrayassembly.Seegure1.
Attach the lift handle catch (6) to the front holes of the 3.
tray assembly using the bolt and nylock nut removed
instep1.Seegure1.
Assemble four 5/16 x 3/4" hex bolts (9) and 5/16" 4.
nylock nuts (14) to the four empty corners in the tray
assembly.Seegure1.
Tighten5. all eight of the 5/16 x 3/4" hex bolts in the
corners of tray assembly.
TOOLS REQUIRED FOR ASSEMBLY
(2) 3/4" Wrenches
(2) 1/2" Wrenches
FIGURE 1
PRE-ASSEMBLED BOLT
6
9
14
PRE-ASSEMBLED NUT
Attach the lift tube assembly (2), the lift handle (3), 8.
and the hitch tube (5) to the rear hole on the right
side of the tray using a 5/16 x 1-1/2" hex bolt (10) and
5/16" nylock nut (14). Tighten the nut then loosen 1/2
turn.Seegure4.
Secure the top hole of the lift handle to the top hole 9.
of the lift tube assembly with a 5/16" x 1" hex bolt (11)
and 5/16" nylock nut (14). Tighten.Seegure4.
FIGURE 4
10
14
3
5
14
11
2