Filter
Top Products
9. Make sure that all parts are properly tightened before
you use the treadmill. Keep the included hex key in a
secure place. The hex key is used to adjust the walking
belt (see page 14). To protect the floor or carpet, place a
mat under the treadmill.
8. Carefully lower the Handrails (6, 7) to the floor. Center the
Frame (55) between the Handrails, and tighten the four
Handrail Bolts (12). Then, raise the Handrails to the verti-
cal position.
See drawing 8a. Attach the Storage Latch Assembly (41)
to the Left Handrail (7) with two 16mm Screws (58).
Make sure that the Storage Latch Assembly is ori-
ented as shown.
See
HOW TO CHANGE THE INCLINE OF THE TREAD-
MILL on page 11
. Adjust the incline legs and insert
the incline pins into the incline legs.
41
7
58
7. Attach the Console Back (4) to the Console (1) with four
16mm Screws (58). Note that there is a slot in the side of
the Console Back for the wire—make sure that no wires
are pinched.
1
58
4
58
58
Slot
6. Set the Console (1) on the Right Handrail (6) and the Left
Handrail (not shown). Finger tighten four Console Screws
(70) (only two are shown) into the Console. After you
h
ave started all four Console Screws, tighten them.
I
nsert the excess Wire Harness (22) down into the Right
Handrail (6). Tighten the three plastic ties around the Wire
Harness, and then cut off the ends of the plastic ties.
22
Plastic
Ties
1
6
70
6
7
8
8a
6, 7
55
12
8