Filter
Top Products
6. Attach the Storage Latch (14) to the left Upright (11) with
two Screws (80). Do not overtighten the Screws.
Tighten all of the bolts used in steps 3 and 4.
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
80
14
11
6
5. Place the Console Base (46) on the Uprights (11) (the
left Upright is not shown). Make a loop in the indicated
cable tie and insert the two Wires (21) through the loop.
Connect the two Wires to the connectors in the Console
Base. Important: Make sure that the Wires are fully
inserted. Pull the cable tie tight and cut off the end.
WARNING: Do not disconnect or connect the Wires
while the treadmill power cord is plugged in.
Thread four Screws (80) into the Uprights (11) and the
Console Base (46). After all four Screws have been
started, tighten the Screws until they are snug; do not
overtighten the Screws.
80
Cable
Tie
21
Connectors
46
11
5
3. Refer to the inset drawing. If there is a plastic tie holding
the Cage Nut (70) in the Right Handrail (88), remove the
plastic tie. Feed the Wire Harness (21) in the right Upright
(11) through the bracket on the Right Handrail (88) as
shown. Using needlenose pliers, grip one of the connec-
tors on the Wire Harness and pull the Wire Harness up
through the hole in the Right Handrail.
Insert the bracket on the Right Handrail (88) into the
upper end of the right Upright (11), with the lower end of
the Right Handrail on the side of the Extension Leg (34)
as shown. Hand tighten a Short Handrail Bolt (89) with a
Washer (39) into the upper end of the Upright.
11
89
39
89
39
34
88
11
3
4. Attach the lower end of the Right Handrail (88) to the
Extension Leg (34) with a Handrail Bolt (91), a Handrail
Washer (92), and a Handrail Nut (93) as shown. Do not
tighten the Handrail Bolt yet. Note: It may be neces-
sary to push on the lower end of the Handrail to align the
hole in the Handrail with the hole in the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described in steps 3 and 4.
4
92
91
93
34
88
6
21
88
70
Tie
11