Filter
Top Products
58
17
Knob
Spring
Collar
Pin
10.Press the Latch Housing (58) into the Left Upright (17).
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin as shown. Insert the pin
into the Latch Housing, and tighten the knob back onto
the pin.
See step 2. Lower the Uprights (6, 17). Tighten the four
3” Bolts (30). Raise the Uprights to the vertical position.
See step 6. Tighten the four 2” Bolts (12). Set a 3-lb.
Weight (not shown) on the bottom hanger on the Weight
Rack (71), a 2-lb. Weight on the middle hanger, and a
1-lb. Weight on the top hanger.
11.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The allen wrench is used to adjust the walk
-
ing belt (see page 17). To protect the floor or carpet, place a mat under the treadmill.
10
9
8. Hold the Console (1) near the Console Base (77). Touch
the right Handrail (32) to discharge any static.
Locate the two wires in the Wire Harness (22) that have
L-shaped connectors on the ends. Press the connectors
onto the two tabs on the switch shown in inset drawing 8a.
Connect the other two wires in the Wire Harness (22) to
the back of the Console (1) in the locations shown by the
arrows in drawing 8. The connectors should slide eas-
ily into the sockets and snap into place (see drawings
8b and 8c). If the connectors do not slide easily and snap
into place, turn the connectors and then insert them. IF
THE CONNECTORS ARE NOT INSERTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
8
22
1
77
32
9. Securely tighten a plastic tie around the Wire Harness (22)
and under the indicated hook on the Console (1) to pre-
vent the Wire Harness from slipping. Tighten the plastic tie
and cut off the end.
See drawing 9a. Set the Console (1) in the Console Base
(77). Make sure that the Wire Harness (not shown) is
not pinched. Next, set the Console Base on the
Handrails (32). Insert as much of the Wire Harness as
possible into the hole in the right Handrail. See step 7.
Tighten the plastic tie shown in step 7 and cut off the end.
Loosely thread six 3/4” Screws (7) into the Console Base
(77) and the Console (1). Loosely thread four 3/4” Screws
into the Handrails (only two Screws are shown). Start all
ten Screws and then tighten them; do not overtighten
the Screws.
9
9a
1
Tie
Hook
7
7
7
77
1
32
32
22
8a 8b 8c