Filter
Top Products
1. Note that the Right Handrail and the Console Base
(not shown) are connected to the treadmill by a Wire
Harness. During assembly steps 1 through 5, be
careful not to pull on or damage the Wire Harness.
With the help of a second person, carefully lay the
treadmill on its side. Position one of the Base Legs
(38) on the base of the Upright (31) as shown. Make
sure that the Base Leg Pads (41) and the Front
Wheel (39) are in the indicated positions. Attach the
Base Leg with two 3/8Ó x 2Ó Bolts (43), two 3/8Ó
Washers (44) and two 3/8Ó Nuts (34).
Carefully turn the treadmill onto its other side.
Assemble the other Base Leg (38) as described.
With the help of a second person, carefully raise the
treadmill to the upright position so the Base Legs
(38) are resting flat on the floor.
2. Without removing the tape from the Latch (18), hold
the Latch against the left Upright as shown. Attach
the Latch to the left Upright (31) with four Screws
(24). Make sure that the Screws are tight, but do
not overtighten them; if the Screws are over-
tightened, the Latch will not slide smoothly. After
the Latch is attached, remove any visible tape.
Note: The inset drawing shows how the parts of the
Latch (18) fit together.
3. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Cut the plastic ties that hold the cage nuts in each
Handrail (30, 32).
Position the Left Handrail (30) on the left Upright
(31). Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer
(22) only a couple of turns into the upper end of the
left Upright and the Left Handrail. Do not tighten
the Bolt yet.
Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer (22)
only a couple of turns into the lower end of the Left
Handrail (30) and the left Upright (31). Do not tight-
en the Bolt yet.
2
24
3
1
5
43
44
41
38
39
31
31
18
Spacer
Springs
Bracket
Latch
34
23
22
31
30
22
23
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires your own phillips screwdriver , two adjustable
wrenches , and scissors .