Filter
Top Products
7
2. Attach the Handrails (69) to the Upright (73)
with four M10 x 45mm Screws (2). Start all four
Screws, and then tighten them.
3. With the help of a second person, hold the con-
sole assembly near the Upright (73). Remove
the tie from the Upright Wire (71).
Connect the Upright Wire (71) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Insert the connectors and the
excess wire into the crossbar on the Upright (73).
2
3
2
71
Console Assembly
Console Wire
73
2
73
69
69
71
Tie
Console
Wire