Filter
Top Products
7
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.
8. Attach the Storage Latch (14) to the left Upright (76) with
two 3/4” Screws (13). Be careful not to overtighten the
Screws.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 11), but do not
latch it. Make sure that the frame is centered between
the Handrails (1).
Firmly tighten all of the bolts and
screws used in assembly steps 2, 3, and 4. Then,
lower the frame to the floor.
13
14
1
76
1
10
46
21
6. Set the Console (10) in the Console Base (46). Be careful
to avoid pinching any wires. Insert the excess Wire
Harness (21) into the large hole in the side of the right
Handrail (1).
Securely tighten the plastic ties on the
bottom of the Console Base to prevent the Wire
Harness from slipping.
Cut off the ends of the plastic ties.
Attach the Console Base (46) to the Handrails (1) with four
3/4” Screws (13)
; do not overtighten the Screws.
6
8
13
13
1
Ties
10
46
7. Attach the Console (10) to the Console Base (46) with
seven 3/4” Screws (13). Make sure that no wires are
pinched. Start all seven Screws before tightening them;
do not overtighten the Screws.
Note: Make sure the in-
dicated 3/4” Screw is not overtightened. Overtightening
the Screw may cause the Console to not function properly.
7
13
Do not overtighten