Filter
Top Products
3. Remove the two remaining Latch Screws (14) from
the left Upright (38).
Without removing the tape from the Latch Bracket
(16) and the Latch Spacer (13), attach both parts to
the left Upright (38) with the four Latch Screws (14).
Make sure that the Latch Screws are tight, but
do not overtighten them; if the Latch Screws are
overtightened, the Storage Latch (17) will not
slide smoothly. Remove any visible tape from the
Latch Bracket and the Latch Spacer.
Note: The inset drawing shows how the Latch
Bracket (16), Latch Springs (15), Storage Latch (17),
and Latch Spacer (13) fit together.
4. Remove the shipping tie from the Left Handrail (4)
and Handrail Spacer (3). Attach the Left Handrail
and Handrail Spacer to the left Upright (38) with two
Handrail Bolts (1) and Handrail Washers (70) as
shown. Make sure that the ramp on the Handrail
Spacer is on the inside as shown. Do not tighten
the Handrail Bolts until step 5 is completed.
Remove the shipping tie from the Right Handrail (32)
and Handrail Spacer (3). Hold the Handrail Spacer
against the right Upright (38) and feed the excess
Wire Harness (53) into the right Upright. Attach the
Right Handrail and Handrail Spacer to the right
Upright with two Handrail Bolts (1) and Handrail
Washers (70). Do not tighten the Handrail Bolts
until step 5 is completed.
5. Note that the wire ties in the Right Handrail (32)
should not be removed. Attach the Console Base
(87) to the Handrails (4, 32) with four Console
Screws (5). Insert the excess Wire Harness (53) into
the right Upright (32). Make sure that the Console
Screws are tight, but do not overtighten them.
Tighten the four Handrail Bolts (1) used in step 4.
6. Remove the backing from the Adhesive Clip (80).
Press the Adhesive Clip onto the right Upright (38) in
the indicated location. Press the Allen Wrench (81)
into the Adhesive Clip.
7. The Console (11) requires three "AA" batteries (not
included); alkaline batteries are recommended.
Open the Battery Cover (12) as shown. Press three
batteries into the battery compartment, with the neg-
ative (Ð) ends of the batteries touching the springs.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Be sure that the tab locks into place.
8. Make sure that all parts are properly tightened
before you use the treadmill. To protect the floor or
carpet from damage, place a mat under the treadmill.
4
6
70
1
4
3
32
3
38
38
Ramps
53
70
1
5
6
7
5
87
Wire ties
32
4
5
53
14
16
17
13
38
3
81
38
80
11
12
Batteries
Battery Cover Tab
13
16
17
15