Filter
Top Products
3. Insert the Wire Harness (53) into the right Upright
(37) as you press the Console Base (45) onto both
Uprights. Insert two Handrail Bolts (77) through each
side of the Console Base and through the Uprights
as shown. The Handrail Bolts must be inserted
from the inside as shown. Tighten a Handrail Nut
(41) with a Handrail Washer (39) onto each Handrail
Bolt.
Tighten all four Handrail Bolts (77) as tightly as
possible. Carefully lift up and push down on the
handrails to make sure that the Console Base
(45) does not move. Regularly inspect and tight-
en all four Handrail Bolts.
4. Attach the Frame Guide (66) to the left side of the
Frame (21) with two Frame Guide Screws (44) as
shown. Be careful not to overtighten the Screws.
Make sure that the thick end of the Frame Guide
is at the bottom.
5. Remove the backing from the Adhesive Clip (2).
Press the Adhesive Clip onto the base of the Upright
(37) in the indicated location. Press the Allen
Wrench (35) into the Adhesive Clip.
6. The Console (49) requires two "AA" batteries (not
included); alkaline batteries are recommended.
Open the Battery Cover (48) as shown. Press two
batteries into the battery compartment, with the nega-
tive (Ð) ends of the batteries touching the springs.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Be sure that the tab locks into place.
4
5
6
21
35
37
2
66
Thick end
44
37
45
39
41
77
77
53
41
39
77
77
37
45
Handrails
3
6
Batteries
Tab
7. Make sure that all parts are properly tightened before you use the treadmill. The use of the remaining parts
will be described in other sections of this manual. To protect the floor or carpet from damage, place a mat
under the treadmill.
49
48