Filter
Top Products
5
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred
to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubri-
cant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires a phillips screwdriver , two adjustable wrenches , and
needlenose pliers .
Attach four Base Pads (63) to the bottom of the Base
(46) with four 3/4” Tek Screws (3). Attach the Wheels
(68) to the outside of the Base with two Wheel Bolts (67),
3/8” Washers (66), and 3/8” Nuts (61) as shown. Do not
overtighten the Wheel Bolts.
68
61
63
63
46
1
67
61
68
67
66
3
3
3
66
63
2. With the help of a second person, carefully tip the tread-
mill onto its right side as shown.
Attach a Frame Spacer (27) to the Frame (79) with a
Spacer Screw (89) as shown.
Identify the Left Upright (53), which does not have a large
round hole near the lower end. Hold the Left Upright so
the indicated small hole is in the position shown. Loosely
thread a Frame Bolt (70) with a Washer (66) and a Star
Washer (29) through the Left Upright and the Frame
Spacer (27) into the Frame (79) as shown. Do not tight-
en the bolts used in steps 2 through 5 until step 5 is
completed.
Refer to drawing 2b. With the help of a second person, tip
the treadmill onto its left side.
Attach a Frame Spacer (27) to the Frame (79) with a
Spacer Screw (89).
Hold the Right Upright (62) so the indicated large hole is
in the position shown. Insert the Wire Harness (60) into
the large hole and out of the top of the Right Upright.
Loosely thread a Frame Bolt (70) with a Washer (66) and
a Star Washer (2) through the Right Upright (62) and the
Frame Spacer (27) into the Frame (79).
2a
2b
70
66
29
27
89
79
53
Large
Hole
Small
Hole
70
66
29
62
60
89
79
27
1. Note: To identify small parts used during assembly,
refer to the PART IDENTIFICATION CHART in the
center of this manual.
¥Hazardous Voltage
¥Risk of Electric Shock
¥Unplug Treadmill before Assembly
/Disassembly.