Filter
Top Products
3. Cut the indicated plastic tie off the Left Handrail (2).
Position the Left Handrail (2) on the left Upright (14).
Loosely thread a Handrail Bolt (15) with a Handrail
Washer (16) into the lower end of the Left Handrail and
the left Upright. Next, loosely thread a Handrail Bolt (15)
with a Handrail Washer (16) into the upper end of the
Left Handrail and the left Upright. Do not tighten the
Handrail Bolts yet.
Attach the Catch (51) and the Catch Spacer (47) to the
left side of the Frame (70) with two 3/4Ó Screws (55). Be
careful not to overtighten the Screws.
15
16
15
16
14
2
Plastic Tie
3
47
70
51
55
26
Bracket
Plastic Tie
57
14
4
6
15
15
16
16
14
57
55
6
55
2
57
4. With the help of a second person, hold the Console Base
(6) and the Right Handrail (57) near the right Upright (14)
as shown. Insert all of the excess Wire Harness (26) into
the Right Handrail and down into the right Upright. Bend
the Wire Harness as shown, if necessary.
Cut the plastic tie holding the cage nut in the Handrail (57).
Next, make sure that the Wire Harness (26) is inside of
the bracket on the Right Handrail (57) and insert the
bracket into the right Upright (14). Make sure that the
Wire Harness is not pinched.
5. Position the Right Handrail (57) on the right Upright (14).
Loosely thread a Handrail Bolt (15) with a Handrail
Washer (16) into the lower end of the Right Handrail and
the right Upright. Next, loosely thread a Handrail Bolt (15)
with a Handrail Washer (16) into the upper end of the
Right Handrail and the right Upright. Do not tighten the
Handrail Bolts yet.
6. Attach the Console Base (6) to the Left and Right
Handrails (2, 57) with four 3/4Ó Screws (55).
Tighten the four Handrail Bolts (not shown) used in
assembly steps 3 and 5.
55 (Back out)
55
55
6
88
88
61
61
10
58
7
7. Back out the three indicated 3/4Ó Screws (55) from the
Console Base (6). Align the holes in the Weight Rack
(58) with the holes in the Console Base. Attach the
Weight Rack with seven 3/4Ó Screws (55) as shown. Be
careful not to overtighten the Screws.
Put the two 1-lb. Weights (88) into the outside slots in the
Weight Rack (58), the two 2-lb. Weights (61) into the next
slots, and the 3-lb. Weights (10) into the inside slots.
8. Make sure that all parts are tightened before you use
the treadmill. Keep the included allen wrench in a se-
cure place. The allen wrench is used to adjust the walk-
ing belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
5
6
6