Filter
Top Products
1. With the help of a second person, carefully raise the
Uprights (14) to the position shown. Note that the
Console Base (6) and the Right Handrail (57) are con-
nected to the right Upright with the Wire Harness (26).
Be careful not to pull on the Wire Harness.
Refer to the inset drawing. Insert one of the Extension
Legs (41) into the treadmill as shown. (Note: It may be
helpful to tip the Uprights [14] in the direction shown by
the arrow as you insert the Extension Leg. Make sure
that the Base Pad [36] is on the bottom of the Extension
Leg.) Attach the Extension Leg with an Extension Leg
Screw (34). Be sure to push on the head of the
Extension Leg Screw while tightening it.
Attach the other Extension Leg (41) in the same way.
5
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver and
adjustable wrench .
Refer to the drawings below to identify the parts used in assembly.
Extension Leg
Screw (34)–2
Handrail Washer
(16)–4
Handrail Bolt (15)–4
3/4” Screw (55)–6
34
41
14
26
14
57
6
1
36
12
55
14
2
2. Attach the Storage Latch (12) to the Upright (14) with two
3/4” Screws (55). Be careful not to overtighten the
Screws.