Filter
Top Products
2. Attach the Handrails (69) to the Uprights (73)
with four M10 x 45mm Bolts (2). Start all four
Bolts, and then tighten each of them.
3. With the help of a second person, hold the con-
sole assembly near the Uprights (73). Remove
the tie from the Upright Wire (71).
Connect the Upright Wire (71) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Insert the connectors and the ex-
cess wire into the crossbar on the Uprights (73).
2
3
71
Console Assembly
Console Wire
73
2
2
73
6
9
69
71
Tie
Console
Wire
4. Attach the console assembly to the Uprights
(73) and the Handrails (69) with six M4.2 x
19mm Screws (3). Be careful not to pinch the
wires.
4
3
69
69
3
3
Console Assembly
73
7