Filter
Top Products
6
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
and rubber mallet .
For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, first
check to see if it has been pre-assembled.
3/4” Screw (43)–12
Silver Ground
Screw (99)–1
Handrail Bolt (44)–2
1/2” Screw (97)–4
Extension Leg Screw (14)–2
Star Washer (25)–4
1. With the help of a second person, raise the Uprights (38)
to the position shown.
Next, insert one of the Extension Legs (15) into the
treadmill as shown; make sure that the Extension Leg is
turned so the Base Pad (33) is underneath it. Note: It
may be helpful to tip the Uprights (38)
in the direction
shown by the arrow as you insert the Extension Leg.
Attach the Extension Leg (15) with an Extension Leg
Screw (14).
Make sure to push on the head of the
Extension Leg Screw while tightening it.
Attach the other Extension Leg (not shown) in the
same way.
38
15
33
14
1