Filter
Top Products
6. Attach the Storage Latch (14) to the left Upright (11) with
two Screws (13). Do not to overtighten the Screws.
See step 4. Tighten the Handrail Nuts (93).
7. Make sure that all parts are properly tightened before
you use the treadmill.
Keep the included allen wrench
in a secure place. The allen wrench is used to adjust the
walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
13
14
11
6
3. See drawing 3a. If there is a plastic tie in the Cage Nut
(70) in the Right Handrail (88), remove the plastic tie. Pull
15cm (6 in) of the Wires (21) out of the right Upright (11).
Route the Wires into the bracket on the Right Handrail
and out of the upper end as shown. (
If necessary, use
needle-nose pliers to grip the ends of the Wires.) Thread
the included plastic tie through the indicated holes in the
Right Handrail.
See drawing 3b. Look into the Right Handrail (88) and
make sure that the Wires (21) are on the indicated side
of the plastic tie. Then, tighten the plastic tie and cut off
the end.
See drawing 3c. Insert the bracket on the Right Handrail
(88) into the right Upright (11), with the lower end of the
Right Handrail beside the Extension Leg (34).
Tighten a
Short Handrail Bolt (89) with a Small Handrail Washer
(39) into the upper end of the Upright.
Attach the Left Handrail (1) as described above. Note:
There are no wires in the left Upright (11).
11
11
1
39
89
34
88
3c
4. Attach the lower end of the Right Handrail (88) to the
Extension Leg (34) with a Handrail Bolt (91), a Handrail
Washer (92), and a Handrail Nut (93) as shown. Do not
tighten the Handrail Nut yet. Note: It may be necessary
to push on the lower end of the Handrail to align the hole
in the Handrail with the hole in the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described above.
4
92
91
93
34
88
6
13
13
88
21
88
21
46
46
1
5a
5b
5. Place the Console Base (46) on the Handrails (88, 1) (the
Left Handrail is not shown). Pull out the two Wires (21)
just enough to connect them to the two connectors in the
Console Base. Plug the Wires fully into the connec-
tors. WARNING: Do not disconnect or connect the
Wires while the treadmill power cord is plugged in.
See drawing 5b. Thread four Screws (13) into the Right
and Left Handrails (88, 1) and the Console Base (46).
Make sure that the Wires (21) in the Right Handrail
are away from the screw holes. After all four Screws
have been started,
tighten the Screws until they are
snug; do not overtighten the Screws.
21
88
70
11
Tie
3a
3b
21
88
Tie