Filter
Top Products
7
2. Have a second person hold the Base (52) in the
position shown.
I
dentify the Left Upright (53) (the Right Upright [54]
has a large hole near the lower end).
Hold the Left Upright (53) so the two small
holes for the latch assembly are on top as
shown. Insert two Upright Bolts (2) into the
bracket on the Left Upright. Attach the Left
Upright to the Base (52) with the Upright Bolts,
two Upright Star Washers (9) and two Jam Nuts
(105). Do not tighten the Nuts yet.
Attach the Right Upright (54) to the Base (52)
in the same way.
2
52
53
105
2
2
105
9
9
9
9
5
4
Large
Hole
Small Holes
3. Slide the two Wheel Housings (45) onto the Base
(52). Attach each Wheel Housing with two Wheel
Housing Bolts (13), two Wheel Housing Washers
(32), and two Wheel Housing Nuts (43).
3
52
13
32
32
45
43
13
32
32
45
43
4. Position the Base (52) as close to the front of the
treadmill as possible, as shown.
See the upper inset drawing. Wrap the wire tie
in the Right Upright (54) around the end of the
Wire Harness (39). Then, pull the other end of
the wire tie until the Wire Harness is extending
from the upper end of the Right Upright. Secure
the Wire Harness to the top of the Right Upright
so that it will not fall inside.
See the lower inset drawing. Press the indi-
cated Grommet (49) into the Right Upright (54).
52
4
39
54
54
54
49
39
Wire Tie