Filter
Top Products
8
6. Hold the Console Assembly (91) near the Right Upright
(54). Touch the Right Handrail (55) to discharge any
static.
Insert the end of the Wire Harness (98) into the hole in
the bottom of the Right Handrail (55) and out of the large
hole in the side. Then, insert the end of the Wire Harness
through the two looped plastic ties.
Press the end of the Wire Harness (98) into the indicated
connector on the back of the Console Assembly (91).
The end of the Wire Harness should slide easily into
the connector and snap into place. If it does not, turn
the end of the Wire Harness and then insert it. IF THE
CONNECTOR IS NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER IS
TURNED ON.
Plastic
Ties
Connector
91
55
98
54
5. Place the Left Handrail (56) on the Console Assembly
(91). Attach the end of the console ground wire to the in-
d
icated small hole in the Left Handrail with the Silver
Ground Screw (8).
Then, attach the Left Handrail (56) to the Console
Assembly (91) with two Console Screws (4), a Crossbar
Screw (5), and a Crossbar Star Washer (12).
Be careful
not to pinch the ground wire.
12
91
4
5
56
8
Console Ground Wire
S
mall
Hole
6
5
98
7. Insert the excess Wire Harness (98) down into the Right
Upright (54). Then, tighten the two plastic ties around the
Wire Harness, and cut off the ends of the plastic ties.
98
Plastic
Ties
54
7