Filter
Top Products
8
5. Hold a Handrail (32) near the Right Upright (6). Feed the
Wire Harness (22) into the hole near the lower end of the
Handrail and out the hole near the upper end of the
Handrail. Note: It may be helpful to use needlenose pliers
to pull the end of the Wire Harness out of the hole.
5
32
22
22
6
6. Open part bag C. Hold the Handrail (32) with the Wire
Harness (22) against the Right Upright (6). Hand tighten
two 2” Bolts (12) with two 3/8” Star Washers (42) into the
Handrail and the Right Upright. Be careful not to pinch
the Wire Harness. Do not tighten the Bolts yet.
Attach the other Handrail (not shown) to the Left Upright
(17) as described above. Note: There is not a wire on the
left side. Do not tighten the Bolts yet.
Orient a Weight Rack (71) as shown, and attach it to the
Right Upright (6) with six Rack Screws (21). Start all six
Screws before tightening them; do not overtighten
the Screws.
Attach the other Weight Rack (not shown) to the Left
Upright (17) as described above.
6
17
22
32
22
71
21
6
12
21
21
42
7. Hold the Console Base (77) near the Handrails (32) (only
one is shown). Insert the Wire Harness (22) through the
looped plastic tie and through the hole in the Console
Base. Remove the tape holding the ends of the wires.
7
77
Tie
Tape
22
22
32
22