Filter
Top Products
9
DIAGRAM OF THE CONSOLE
Speed Control
Incline Control
Displays
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 8).
Next, locate the circuit break
-
er near the power cord. Make
sure that the circuit breaker is
in the reset position.
Stand on the foot rails of
the treadmill. Find the
clip attached to the key,
and slide the clip onto
the waistband of your
clothes.
Next, i
nsert the key fully into the console. After a
moment, the displays will light.
Test the clip by care-
fully taking a few steps backward until the key is
pulled from the console. If the key is not pulled
from the console, adjust the position of the clip.
Follow the steps below to operate the console.
Insert the key fully into the console.
A few seconds after the key is inserted, the dis-
plays will light.
Press the Speed
▲
▲
button to start the walking
belt.
A
moment after the button is pressed, the walking
belt will begin to move. Hold the handrails
and
begin walking.
2
1
CAUTION: Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing at the
right) while operating the treadmill.
• Adjust the speed in small increments to
avoid sudden jumps in speed.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and place only a sealed
water bottle in the water bottle holder
.
Key
Reset
Note: If there is a thin sheet of
plastic on the console, remove it.
Clip